Nissan Micra K11 Rear Exhaust Sports Box

Nissan Micra K11 Rear Exhaust Sports Box

• TIG Welded
• Compatible with Factory exhaust systems
• 2" Bore
• Gasket Included
• Options for both 2nd Facelift (00-02 - without Cutout) and Pre-Facelift/ 1st Facelift (93-99 - With Cutout) models (See Notes Below)

Please note, its important to select the correct version for your back box.

• The Pre/1st Face-lift boxes sit higher to suit the bumper cut out.
• The 2nd Face-lift boxes sit lower as there is no bumper cut out.

If ground clearance is a concern, purchase a Pre-1st Face model. If fitting to 2nd Facelift models, you will need to trim your bumper

Potential Fitment Issues
There is a lot of variance with OE-Aftermarket exhaust systems, typically the 2 bolt flange the silencer attaches near the axle. During our initial development of our K11 Exhaust systems, we had a total of 4 OE-Aftermarket Mid-Sections side by side and no two where the same. With the OE-Aftermarket exhaust systems, they are typically poor construction due to manufacturing times, which leads to the flange being both at different angles and rotations - But due to how the standard rear silencer sits, it's no concern if the angle is off slightly as there is no actual tip which protrudes through the bumper.

When fitting our sports box to an OE-Aftermarket center exhaust, you may experience issues with the Tip lining up correctly in the bumper cut out. To counter this, you may need to use different exhaust rubbers to correctly position the tip in the bumper. Typically these issues are not present with our Full-System due to the center section being adjustable.

This product is not intended to be used on public highways and should be installed by a qualified professional. This Product is not endorsed by Nissan Motor Company Ltd